柴油發電機組啟動前要加注冷卻液。加注時，應翻開發動機上部冷卻體系的放氣閥門，緩慢地將冷卻液從散熱水箱的加水口加入到發動機中，直至沒有氣泡再?gòu)姆艢忾y門中排出停止。冷卻液應加注至散熱水箱加水口頸部下方，不宜過滿。加注結束后，將放氣閥門封閉，并將水濾器裝置座上的截門翻開，以便DCA4添加劑能夠混合進入冷卻體系中。冷卻體系所用冷卻液主要應由純凈水、防凍液及DCA4添加劑3種成分構成，每升冷卻液含50％的純凈水、50％的防凍液和0．5單位的DCA4添加劑。配好的冷卻液一年四季均可運用，而且能夠接連運用兩年。

　　純凈水因?yàn)榻?jīng)過凈化，因而可避免形成水垢發電機組防凍液系指工業用的乙烯乙二醇或丙烯乙二醇，能夠下降水的冰點及進步水的沸點。防凍液的濃度應為40％。68％，濃度過高或過低均會影響冷卻液的防凍能力。在大多數氣候條件下，引薦運用的防凍液濃度為50％，此刻冷卻液的冰點可達—33cC。DCA4添加劑可在水體系內外表形成一層保護膜，以避免缸套和機體發生穴蝕及阻撓沉淀物堆積?？得魉?span style="font-size: 16px; font-family: Calibri;">C系列以上的發動機都安有水濾器，水濾器除了有過濾介質外，內部還含有DCA4添加劑。DCA4添加劑的濃度通常要求堅持為每升水中含有0.32～0.79單位，能夠經過DCA4檢測包來檢測。

Before starting the diesel generator set, it is necessary to add coolant. When adding fuel, the vent valve of the upper cooling system of the engine should be opened, and the coolant should be slowly added from the water inlet of the radiator to the engine until there are no bubbles before being discharged from the vent valve. The coolant should be added to the neck of the radiator water inlet and should not be overfilled. After filling, close the vent valve and open the shut-off valve on the water filter device seat so that DCA4 additive can mix into the cooling system. The coolant used in the cooling system should mainly consist of three components: pure water, antifreeze, and DCA4 additive. Each liter of coolant contains 50% pure water, 50% antifreeze, and 0.5 units of DCA4 additive. The prepared coolant can be used all year round and can be used continuously for two years.

Purified water can avoid the formation of scale due to purification. Antifreeze for power generation units refers to industrial ethylene glycol or propylene glycol, which can lower the freezing point of water and increase the boiling point of water. The concentration of antifreeze should be 40%. 68%, high or low concentration will affect the antifreeze ability of the coolant. In most climatic conditions, the recommended concentration of antifreeze is 50%, and the freezing point of the coolant can reach -33cC at this moment. DCA4 additive can form a protective film on the inner and outer surfaces of the water system to prevent cavitation and hinder sediment accumulation in the cylinder liner and body. Cummins C-series and above engines are equipped with water filters, which not only contain filtering media but also DCA4 additives inside. The concentration of DCA4 additive is usually required to be 0.32-0.79 units per liter of water, which can be detected by the DCA4 detection kit.